With a focus on frameless shower enclosures for sliders, custom euro glass is a top frameless shower glass supplier in the USA and Australia.

This is for informational proposes only. Make sure your contractor follows these few simple steps when building your shower...

BUILDING NEW SHOWER CURB

Shower checks shouldn't be level from inside to outside. The shower check ought to be leaned toward within the shower. This permits water to run once more into the shower rather than out onto the washroom floor. A normal control will be inclined atleast 1/8"- 1/4", which addresses about a portion of an air pocket fair and square. You can utilize tile on top of the control or a strong piece of stone or marble. A strong piece marble, rock or silestone for the highest point of the check, half-wall or shower seat, gives better insurance against water interruption.
Frameless shower nooks are not destined to be sealed. While you shouldn't have issues around fixed boards, as they are fixed with a top notch, buildup safe silicone, yet around genuine entryway (and transom in the event that assuming you have steam shower nook) they can spill with an immediate splash of water. Frameless shower entryways in all actuality do have little holes at the pivots and pivot side along the wall, in this manner its critical to have the highest point of the control slanted internal, so the dribbling water is streaming once again into the shower.
Ensure you introduce the tiles outwardly of the check in a similar way as within. Level and adjust the tiles, keeping them lined up with within tiles. Recollect that the external tiles ought to be roughly 1/8"- 1/4" (a portion of an air pocket) taller than within column to give the top "legitimate pitch". Know more 

Contact :

Location: 5544 Nicholson Ln, Rockville, MD, United States, Maryland

Call: +1 301-576-2226